Scotty97

Well I'm 28 and only now getting into it, been riding moto trials for a few years thou!!

Ok once I've run it for a bit, i'l check them

Yeah I know that, I got a spacer in there prob about 8mm thick (the spacer came with BB) If you take the bolt back off, u can see that the crank could go on another 1 mil. thinking about it, could the bolt be bottoming out???

I'am currently installing my new cranks (try-all) onto a new Fsa bottom bracket (I think), the sprocket side went on nice, all the way up against the spacer, the opposite side went most of the way on and then seemed to go tight, i can't get it to tighten any more, it's about one mil off the spacer, so the spacer moves back and for slightly?? Is this ok? Has anyone else seen this???

I'am currently installing my new cranks (try-all) onto a new Fsa bottom bracket (I think), the sprocket side went on nice, all the way up against the spacer, the opposite side went most of the way on and then seemed to go tight, i can't get it to tighten any more, it's about one mil off the spacer, so the spacer moves back and for slightly?? Is this ok? Has anyone else seen this???

Hi, I'm after a cheap set of Tyres to ride street!! I have Halo combat 24" rims Would these be suitable PIRHANA 24” JUMP BIKE TYRE · Unusual tyre size · 24 inch · 24 x 2.2 · Wire beaded · Nice quality street tread · Hard to find as nice as this!

AWESOME Documentary!!!

I been looking to buy a new chain Which is stronger 1/8 or 3/32???

DT swiss spokes all seem to be double butted???? Any one else had any different ones off them I'm after 242mm White spokes!!!!

Right then, got a 24" bike for street, got a 18T front sprocket, what's people running on the rear??? I'l be riding street only!!!!

Funny enough they are the ones I been looking at, was advised to get 170mm ones, but would 175mm be ok on a 24" bike. I'm only a beginner so prob wouldn't notice the difference??

Right I'm after my first set of cranks, as it's my first build! Got 50 quid to spend on a set of ISIS type cranks What would you recommend????

Any one know a good spoke length calculator?? and where i can get white spokes for my 24" wheel build HUB : Hope Bulb (rear) RIM : Halo SAS (24"0

Thanks, I have done a bit of reading, but nothing beats first hand comments!!

Any one tried the following Looks a nice bit of kit CLARKS S2 HYDRAULIC DISK BRAKE FRONT WHITE