Sign in to follow this  
Followers 0
Maxx

Removing Stan Ti barbed fittings

6 posts in this topic

I usually remove steel barbed fitting by heating them, then I just pull the hose with a plier.

But I wonder what will it do if I heat the titanium barbed fittings? Will they be still usable ?

Thanks !

Share this post


Link to post
Share on other sites

Just use a sharp knife and cut them away. No need to use any heat.

1 person likes this

Share this post


Link to post
Share on other sites

This is what I used to do before I start to remove them by heating them, but I often get some scratch on them if I cut the hose with a knife and I don't think it's good for etancheity.

Share this post


Link to post
Share on other sites

This is what I used to do before I start to remove them by heating them, but I often get some scratch on them if I cut the hose with a knife and I don't think it's good for etancheity.

cutting will be fine, you dont see the part you cut anyways...

Share this post


Link to post
Share on other sites

cutting will be fine, you dont see the part you cut anyways...

It can start leaking if the cut is deep enought so you must be carefule.

Share this post


Link to post
Share on other sites

maybe if you are using a circular saw! a knife will be fine.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.