Sign in to follow this  
Followers 0

Internal Routing Cables

2 posts in this topic

As title says really, before I continue I would like to add this frame is cracked and bent before I got excited with a drill haha.

I have tried to drill where I think is not a stressful place for the frame. I drilled an initial hole of 3mm then changed it to 6mm. Following this I angled the drill the angle that the cable would be gong into and out of the frame based around looking at my own bike. 

You can see with the cable going through the seat clamp area was not idea however with other frames like Marino’s the seat clamp is on top so if you cut your post down it would still clear fine (however in this instance it worked out well as I was able to see and show what was happening). 

Has any body got any advice on what else could be done? I thought of heat treating the area to make it stronger. Has anyone got any ideas or has this been done before? 

Cheers for responses in advance 










Share this post

Link to post
Share on other sites

Looks cool..

1 person likes this

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.