CrOcKeR Posted March 6, 2007 Report Share Posted March 6, 2007 is there any specific way for tightening them or is it just wack the spanner on and spin? Quote Link to comment Share on other sites More sharing options...
liam_thornton Posted March 6, 2007 Report Share Posted March 6, 2007 It depends on what hub it is. Quote Link to comment Share on other sites More sharing options...
Bearded Midget Posted March 6, 2007 Report Share Posted March 6, 2007 simply wack on a cone tightner a spin m8 only takes a quarter of a turn maybe depending how loose it is Quote Link to comment Share on other sites More sharing options...
ned1 Posted March 6, 2007 Report Share Posted March 6, 2007 use 2 17mm spanners but only tighten them finger tight..any tighter and the huib will jsut f**k up real easily ..or buy a sealed hub Quote Link to comment Share on other sites More sharing options...
spmcfadden Posted March 6, 2007 Report Share Posted March 6, 2007 If there isn't enough space to get your fingers on the cones then you can use a screwdriver to help turn them round if you haven't got a small enough spanner. Tightening them too much will stop the bearings rolling so using fingers should be fine, not worth paying for a specific cone spanner. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.