Wheelbuilding Help

[Tony Harrison]

Does anybody know if the Hope Mono has the same outer dimensions (flange offset and diameter) as the Hope XC/Sport (splined disk attachment)?

I'm trying to calculate the spoke lengths to build the XC onto a BMF/DX32 rim (32H) and I'd rather use Hope's hub measurements (given on their site for the Mono) as they're most likely to be accurate.

Also, does anybody happen to know the inside diameter of the BMF/DX32? I could go home and measure them but I thought I'd ask incase anyone knows offhand.

Thanks.

[Tartridge]

Does anybody know if the Hope Mono has the same outer dimensions (flange offset and diameter) as the Hope XC/Sport (splined disk attachment)?

Also, does anybody happen to know the inside diameter of the BMF/DX32? I could go home and measure them but I thought I'd ask incase anyone knows offhand.

←

Slightly different.

Its approx 548 (or 550 if its got eyelets), I've found that 266 drive 268 disc works well with that combo.

Edit: Hang on, which hub are you using Ian? Ta.

[Tony Harrison]

It's the old XC/Sport. It has the old spline/lockring disk attachment and a Hope sticker rather than an etched logo. So it's a few years old - would the spoke length be much different to a Mono setup?

Thanks again.

[Tartridge]

Yeah, same spoke lengths as the mono :S

Alternatively you could measure yourself, tis a piece o piss :S

[Tony Harrison]

Yeah might have a go, then I can use your measurements to make sure I got it right.

Thanks for that - much appreciated.