trialskidy Posted November 24, 2011 Report Share Posted November 24, 2011 Hi i have been having a problem with my rear hs33 brake it keeps slipping i have bled it like 3 times today so it isnt that its like theres oil on the rim but no oil any advice.? Quote Link to comment Share on other sites More sharing options...
trialsiain Posted November 24, 2011 Report Share Posted November 24, 2011 clean the pads. Have you got a grind ? Quote Link to comment Share on other sites More sharing options...
trialskidy Posted November 24, 2011 Author Report Share Posted November 24, 2011 clean the pads. Have you got a grind ? Ok il give that a try and yes i have a grind rim. Quote Link to comment Share on other sites More sharing options...
trialskidy Posted November 24, 2011 Author Report Share Posted November 24, 2011 Oki i just cleaned the pad's and it is still the same... Quote Link to comment Share on other sites More sharing options...
monkeyseemonkeydo Posted November 24, 2011 Report Share Posted November 24, 2011 Clean the rim or regrind. Quote Link to comment Share on other sites More sharing options...
trialsiain Posted November 24, 2011 Report Share Posted November 24, 2011 Have you recently changed rear tyre or had it off because i put a new tyre on and its made my brake Sh*t. I think the rubber dust gets on grind or something 1 Quote Link to comment Share on other sites More sharing options...
trialskidy Posted November 24, 2011 Author Report Share Posted November 24, 2011 Clean the rim or regrind. Il try and clean it but i can't grind it without a grinder Have you recently changed rear tyre or had it off because i put a new tyre on and its made my brake Sh*t. I think the rubber dust gets on grind or something I changed my tyre about 3 week's ago it's been oki till today. Quote Link to comment Share on other sites More sharing options...
Le @ Tnn Engineering Posted November 25, 2011 Report Share Posted November 25, 2011 If you've even got the smallest amount of oil on your pads (during the bleed) there gone. Sand .5mm off them or even better replace them. It's fair to say it's very easy to have oil leak down your slave cylinders onto your pads. Quote Link to comment Share on other sites More sharing options...
monkeyseemonkeydo Posted November 25, 2011 Report Share Posted November 25, 2011 If you've even got the smallest amount of oil on your pads (during the bleed) Another excellent reason to run a water bleed! 1 Quote Link to comment Share on other sites More sharing options...
bannerboy1 Posted November 27, 2011 Report Share Posted November 27, 2011 have you got tar on the rim Quote Link to comment Share on other sites More sharing options...
err Posted November 27, 2011 Report Share Posted November 27, 2011 (edited) did you wind the tpa all the way out before you bled it? if not then the lever piston might be bottoming out before the brake reaches full travel edit: i have an echo lever and this happened, might be different for normal hs33 levers Edited November 27, 2011 by err Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.