DannyBazz (:

I have seen this before on some of my mates bbs... Its fine to run it like that, they've been doing so for as long as I remember without any problems

12 sounds about right?

I think I'm the only one who actually ever goes on a ride that lazenby organises Missed out on sheffield last time, fell off bike on way there ROFL. Deffo up for this though

Ha, can't be arsed finding another picture then uploading it etc...

Front rim looks exactly like an 05 CNC. Did you just use a grinder with a smoothing disc on?

Rock blues in CNC

Why do you keep asking to buy peoples bikes just put a wanted up... If someone wants to sell you one, they will.

Yeah, but F/R chris kings, thats more than 500 already...

Probably about £600/ £650 I'd say....

I bled my old one with Dot 5.1 Lol, sorry :$

Dot 5.1... And with the magura disc brakes... you bleed them from the back. Its the same bleed bolt as a magura, so fill your syringe up, and screw the bolt into the bleed hole on the piston. Pump it all through, fill the reservoir to the top, then ROLL your Diaphram (little rubber seal under res. cap) on. Bleed done

You like to call me tar boy hahaha

I had this problem.... on my hope mono. Just went out one day, lost all its power. Gave it a right good clean, inside the pistons and everything. new pads, cleaned rotor, fresh bleed, set up perfect to the rotor. Power is back to normal now

+1

I'll go will bring bancroft and sam day aswell xxxxx

dot 5.1 replaced dot 4 because its better in every way

Lmao you couldn't resist that bank

What pedals and what cranks? I'm assuming tensile though... as the "thing" you describe that came off with the pedal sounds like the insert... and as far as I'm aware, Tensile are one of the only companies to have inserts. May be wrong though

Just keep riding around with the lever pulled in. Instead of hot water, pud some muddy water on your rotor instead. Not too sure on the SD lever though....

I live a 20 minute train journey. Theres loads of riders in and around bradford so its all good

Thats because they're kids mat

Yeah... Mine is under house insurance, and covered for £1600. Didn't have to do anything hardly... just got a valuation from LBS, sent it off and that was that

Why would it even matter to you billy, you're a smooth rider so it would take you a while to put any rim through, really.

If your grips are too hard, (And Rubber) put them in microwave to soften them up. They will feel so much nicer.

I really struggle with taps too. I think that if I tap the front wheel too low I'll go over the bars