Just spent the best part of an hour sorting my caliper out, changed the pads, bled it and put it back on my bike.
I had a little piece of wood in between the pistons when bleeding, and the old stuff came out fine, put new fluid in, and starting pumping, lots of air came out, refilled and did the same again etc... The lever started to get harder to pull in and the "hard" bit came sooner, so I stopped at that point when their was no more air bubbles, topped up the fluid one last time, put the cap on, put my caliper on my bike and the bloody lever is just pulling all the way in?
The bleed nipple is tightened right up, there is no fluid leaking from anywere.
Anyone got any ideas?