fatty r

Hi so I have a pair of cannondale ultra forks with head shock I was wondering if it’s possible to press out the steerer tube and press in a standard 1 1/8 steerer. Here’s how it is currently any thoughts?

A good mid school techy street vid with a good tune

these look somewhat similar

vario styx

bearings out of a headset / caged bearings or figit spinner bearings are small dunt the outer race with a hamme should crack open flick out bearings just a thought

ak-mtb#3 had abtrials section cant find on you tube unfortunately mike bentham ie miketrials trialskings new world disorder 2 fat tyre fury were some of my inspirations / motivators

not sure bud not fully sure how to mesure it up either

well after 10 years out of trials and the bike hanging on the garage wall its time to start riding agin some new parts and a freshen up here she is

hi thought i show a make frome the end of last year ended up my dads christmas present cut a knife blank out of a lump of plough steel a cupple years ago then decide one nighe id finish it so after a cupple of evenings in the shed i ended up with this turned out better than i thought it would now my dad is gnoing to see if he can make a sheith for it

always liked these i remember seeing the polished version in halfords inverness in about 2003

bite the bullet get a chris king new or seccond hand all agro gone lol happy days

toxic rowan johns for me

how much pad material i on those pads at the back there huge the chain tensioning screws are strange

happy birthday kiddo have a good one

im out work have me in fu**ers